Chemiluminescent Reagent Kit (ab79907)


  • Product nameChemiluminescent Reagent Kit
  • Product overview

    A 2 component chemiluminescent kit for the detection of horseradish peroxidase (HRP) in western blotting.


    The Abcam chemiluminescent reagent for detecting proteins is extremely sensitive and has a high signal-to-noise ratio. This new non isotopic system is a high performance chemiluminescent substrate for peroxidase. It enables less than 10 picogram of protein to be detected within 30 seconds to 1 minute on exposure to X-ray film.

  • Notes

    Instructions for use on membrane with proteins immunoblotted with peroxidase:

    1) Add 1 drop of oxidant Reagent B to 1ml of substrate Reagent A (125ul of reagent covers 1cm2 membrane). This solution should be used immediately or can be kept at +4 degrees C short term.

    2) Immerse the membrane in chemiluminescent reagent for 1 to 10 minutes. Remove excess reagent and cover the membrane with a plastic sheet. Put the plastic covered membrane into contact with light sensitive film in an exposure chamber. Develop the film after 30 seconds to 10 minutes exposure. The time of further radiographic exposure can be adjusted for best results and multiple copies, from the previous results.

  • Tested applicationsSuitable for: WB, Dot Blotmore details



    Our Abpromise guarantee covers the use of ab79907 in the following tested applications.

    The application notes include recommended starting dilutions; optimal dilutions/concentrations should be determined by the end user.

    Application Abreviews Notes
    WB Use at an assay dependent concentration.
    Dot Blot Use at an assay dependent concentration.

    Chemiluminescent Reagent Kit images

    • Various quantities of total cell protein were separated by SDS PAGE 10% and transferred onto nitrocellulose membrane.

      C-met protein (145 kDa) was probed with rabbit anti-C-met antibody and goat anti-rabbit-HRP. The blot was then developed using the Chemiluminescent system.

      A: 1 min delay before contact between membrane impregnated with Chemiluminescent reagent and film. Exposure time: 1 min.

      B: 30 mins delay before contact between membrane impregnated with Chemiluminescent reagent and film. Exposure time: 5 mins.

    References for Chemiluminescent Reagent Kit (ab79907)

    ab79907 has not yet been referenced specifically in any publications.

    Product Wall

    Thank you for your interest in ab79907.

    I'm sorry to say we do not have small sample sizes available for our products. The only sizes available are those noted on our online product datasheets.

    Please contact me again if you have an...

    Read More

    Unfortunately, we haven't tested this. However, I would like to refer you to the manual of the Eclox water test kit, and in doubt contact the manufacturer.